Daktronics G-1000-34-R - Manual (Page 14)

Mechanical
Installation 2-2
1. Attach the angle bracket to the d" bolts on the back of the display using d"
washers and nuts.
2. Mount the customer specified mounting brackets to the wall.
3. Position the display and its mounting angle brackets over the wall mount brackets
as shown in Drawing A-79703.
4. Attach the two support brackets together using customer supplied hardware.
5. Be sure that all mounting hardware is tight before releasing the display.
2.2.2 Pole Mount
Reference Drawings: Pole Mount . . . . . . . . . . . . . . . . . . . . . . . Drawing A-79702
Refer to Drawing A-79702 for a suggested mounting method. The location of the poles
needs to be determined by the customer. The number of poles needed and the pole
structure and footings must be reviewed by a qualified structural engineer and meet all
local codes.
One (1) Daktronics provided mounting kit includes:
C channel (qty. 1)
C angle (qty. 1)
C d" nuts (qty. 2)
C d" lock washers (qty. 2)
C ½" threaded rods (qty. 4)
C ½" nuts (qty. 8)
C ½" washer (qty. 8)
L
Note: A multi-line display requires two mounting kits.
1. Mount the channel to the d" bolts on the back of the display using d" washers
and nuts.
2. Drill a 9/16 " hole in the opposite flange of the mounting channel for each of the ½"
threaded rods.
O
Note: One threaded rod will go to each side of the
mounting pole. The threaded rods should NOT pierce any of the pole’s
flanges (refer to Drawing A-79702).
3. Position the display on the pole.
4. Use ½" nuts and washers to attach the threaded rods to the channel.
5. Position the angle(s) on the opposite side of the pole from the display and slide the
angle(s) onto the threaded rods. Secure the angle(s) with ½" nuts and washers.
6. Be sure that all mounting hardware is tight before releasing the display.