Daktronics G-1000-34-R - Manual (Page 13)

Mechanical Installation 2-1
Section 2: Mechanical Installation
The Daktronics Product Manager’s engineering staff must approve any changes that
may affect the weather tightness of the display. This to include, but not limited to, the
border shrouding and back sheets. If ANY modifications are made to the weather
tightness of the display, detailed drawings of the changes MUST be submitted to our
engineering staff for evaluation and approval or the warranty will be null and void.
Daktronics is not responsible for the integrity of the mounting structure or any
mounting hardware not provided by Daktronics. It is the customers responsibility to
ensure that the structure and any additional hardware have been approved by a
qualified structural engineer.
2.1 Mounting Kit
An optional mounting kit is available when ordering a display. The mounting kit includes the
hardware to either mount the display on a pole or to a wall. Please specify the desired mounting
method when ordering a mounting kit. When using a Daktronics mounting kit, refer to the
instructions in Section 2.2.
2.2 Cabinet Display Mounting
L
Note: There are end caps located at either end of the display for maintenance access. Care
must be taken when mounting the display not to obstruct the end caps. The following two example
mounting methods, wall mount and pole mount, take this into consideration.
2.2.1 Wall Mount
Reference Drawings: Wall Mount . . . . . . . . . . . . . . . . . . . . . . Drawing A-79703
L
Note: Because each site differs, the Daktronics wall mount kit is not a complete
installation kit. It is the customer’s responsibility to determine the proper wall mounting
method and location.
Refer to Drawing A-79703 for a suggested mounting method. The number of wall
brackets needed and the wall structure must be reviewed by a qualified structural engineer
and meet all local codes.
One (1) Daktronics provided mounting kit includes:
C angle bracket (qty. 1)
C d" lock washers (qty. 2)
C d" nuts (qty. 2)
Note: A multi-line display requires two mounting kits.