Daktronics CE-1010 - Manual (Page 6)

All references to drawing numbers, appendices, figures, or other manuals are
presented in bold typeface, as shown below.
“Refer to Drawing B-206146 for the power supply connections.”
Additionally, drawings referenced in a particular section are listed at the beginning
of that section as seen in the following example:
Reference Drawing:
Schem; Primary Signal, Internal W/.QC ............................ Drawing B-206146
Daktronics signs are built for long life and require little maintenance. However, from
time to time, certain sign components will need replacing. The Replacement Parts
List in Section 7 provides the names and numbers of components that may need to
be ordered during the life of the sign. Most sign components have a white label that
lists the part number. The component part number is in the following format: 0P-_ _
_ _-_ _ _ _ (circuit board) or 0A-_ _ _ _-_ _ _ _ (multi-component assembly).
Following the Replacement Parts List is the Daktronics Exchange and Repair
and Return Programs. Refer to these instructions if any sign component needs
replacement or repair.
1.1 Safety Precautions
1. Read and understand these instructions before installing.
2. Be sure that the display is properly grounded.
3. Disconnect power before working on the display.
4. Do not modify the displays or attach any panels or coverings to the display
without the express written consent of Daktronics, Inc.
5. Most products are equipped with a 3-wire grounding-type plug, a plug
having a third (grounding) pin. This plug will only fit into a grounding-type
power outlet. This is a safety feature. If you are unable to insert the plug
into the outlet, contact a qualified electrician to replace your obsolete outlet.
Do not defeat the purpose of the grounding-type plug.
1.2 Display Overview
The Daktronics DataTrac CE-1010 Indoor LED displays have been designed and
manufactured for performance, reliability, easy maintenance, and long life. The
displays consist of an array of LED pixels. The configuration of the LED pixels is
dependent on the family of LED displays. The standard character is seven pixels
high by five pixels wide.
The DataTrac CE-1010 system is available with DataView or Venus 1500 protocol
for message control. The PC controls one or more DataTrac sectional displays. The
displays are offered as single-face sectional displays, which are single-sided stand-
alone units. They can be mounted side-by-side and stacked on top of each other to
create a larger display.
Introduction 1-2