Daktronics CE-1010 - Manual (Page 11)

Mechanical Installation 2-1
Section 2: Mechanical Installation
Reference Drawings:
Shop Dwg; CE-1010-***-1.2-RG-Thin Mount ...........................Drawing A-154011
Shop Dwg; CE-1010-4**-2.1-RG-Thin Mount...........................Drawing A-151214
Shop Dwg; CE-1010-***-2.1-RG-Thin Mount ...........................Drawing A-152954
Shop Dwg; CE-1010-***-3.2-RG-Thin Mount ...........................Drawing A-151283
Shop Dwg; CE-1010-***-4.2-RG-Thin Mount ...........................Drawing A-154044
Spacing Plate; XX.XX" Tall-Thin Mount....................................Drawing A-152630
Shop Dwg; Install Notes-Thin Mount ........................................Drawing A-152599
Mtg Brkt Assy; CE-10**-824-2.1-Thin .......................................Drawing A-155773
Shop Dwg; Install Details CE-1010-1672-2.1-Thin...................Drawing B-155789
Generic; System Riser Diagram ...............................................Drawing A-113523
The sectional display models shown in Drawings A-154011, A-151214, A-152954, A-
151293 and A-154044 are available in various standard sizes and can be arranged to create
larger display sizes. The arrangement of these sections requires Daktronics contract
engineering.
Daktronics contract engineering and the Daktronics project manager will provide installation,
layout, and riser diagrams once the overall display size has been determined. Drawings A-
152630, A-152599, A-155773, and B-155789 are typical illustrative drawings of those that
are contract specific, and are made available by the Daktronics project manager. Installation
drawings are also included in the installation kits that come with the display section(s).
It is important to have received and reviewed the installation drawings and riser
diagrams before installation begins. Installation personnel should be familiar with these
drawings and have copies of them on site.
Note: Daktronics engineering staff must approve any changes made to the display. If any
modifications are made, detailed drawings of the changes must be submitted to Daktronics
for evaluation and approval, or the warranty may be void.
Refer to the shop drawings referenced above, and the other drawings provided by the project
manager.
2.1 Support Structure Design
The wall, framing members, or structure that will support the Daktronics supplied Z-
brackets and display sections are to be designed to support the weight of the
completed system. Review all drawings to determine special requirements and the
total system weight. It is the customer’s responsibility to ensure that the installation
will meet local codes and or standards. Daktronics is not responsible for the
installations or the structural integrity of support structures done by others.