Daktronics DataTime Outdoor LED Time & Temperature Displays - Manual (Page 35)

LCD Screen Action
CURRENT FUNCTION
TIME AND TEMP
Power is provided to the DM-100 controller
though the serial cable on an outdoor display
and by a wall pack transformer for an indoor
display.
This display appears briefly.
CHANGE FUNCTION?
PRESS SET FUNCTION
This message appears next on the screen.
If “TIME and TEMP" was shown on the bottom
line of the LCD during start-up, do nothing. The
controller will automatically default to previous
Time and Temp settings. (The controller will
remember the last function used, so you should
only have to do this with a new controller or
switching between DataTime and other
DataMaster displays.)
If a function other than “TIME AND TEMP” was
shown on the bottom line of the LCD during
start-up, press the <SET FUNCTION> key while
the second LCD prompt is displayed.
You only have 1 or 2 seconds to push it. If you
miss it you have to unplug power and try again.
Menu Items
Pressing the <MENU> key accesses the settings listed below:
On power-up, the DataMaster 100 LCD display will default to showing the current display
settings. The sequence preview will show the sequence order and display formats currently
selected. The following menu items text will be shown on the LCD (the <↑↓> to select):
1. Daylight Savings Setting
2. Set Time (12hr/24hr)
3. Temp ºF Offset
4. Temp ºC Offset
5. Time Format/Hold Time
6. Temp ºF Format/Hold Time
7. Temp ºC Format/ Hold Time
8. %RH - format
9. Sequence Order
10. LED Test?
11. Modem Settings
12. Display Status
DM-100 Controller 31