Daktronics DataTime Outdoor LED Time & Temperature Displays - Manual (Page 12)

Connection from Sensor to the Display Driver
If the distance from the temperature sensor to the display is greater than the provided 25 foot
(7.6 m) cable, a 4-conductor shielded cable can be connected from the sensor to TB1 on the
display driver board.
1. The display's power must be OFF when attaching the internal sensor cable to the host
driver.
2. Connect the temperature sensor to the terminal block (TB1) on the host driver. Refer
to Figure 7 and the table below for the correct connections.
Figure 7: Temperature Sensor to Display Driver Connections
CAN Temperature Sensor (TB1) Field Cabling MASC Driver to CAN
Pin 1 (+5V CAN) Red Pin 2 (+5V CAN)
Pin 2 (CAN H) Green Pin 4 (CAN H)
Pin 3 (CAN L) White Pin 5 (CAN L)
Pin 4 (GND CAN) Black Pin 3 (GND CAN)
Shield Pin 3 (Shield)
8 Mechanical Installation