Daktronics DataTime Outdoor LED Time & Temperature Displays - Manual (Page 17)

1. Mount the J-box at the display.
2. Select the host driver by inserting the Protocol-4 plug into the five-pin protocol jack
(J20).
3. Route a six-conductor, 18 AWG, shielded signal cable through conduit from the J-box
to the driver enclosure in the host display. Fifty feet (15.2 m) of signal wire is
provided.
4. Connect the signal wire from the J-box to the driver enclosure as shown in Figure 9
and listed in the table. Refer to Drawings A-938369 and A-938300 for additional
information.
Figure 9: Direct Connection from Outdoor Location
Wiring from J-Box to Host Driver Enclosure
J-Box Pin Number Cable Color Enclosure Terminal Block
Pin 1 Red 12 V DC Out (+)
Pin 5 Black 12 V DC Out (-)
Pin 5 White Signal IN (-)
Pin 6 Green Signal IN (+)
Pin 8 Brown Signal OUT (+)
Pin 9 Blue Signal OUT (-)
Electrical Installation 13