Daktronics DataTime DF-1012 Time & Temperature Display - Manual (Page 35)

DM-100 Controller 31
Set Degrees C Temperature Offset
Use the Set ºC Temperature offset menu to set the degrees Celsius offset temperature. This is the value (in
degrees) that the display will automatically increment or decrement the Celsius temperature value.
Time & Temperature Format/Hold Settings
Modify a hold time for time and temperature (both ºF and ºC) by pressing the ENTER/EDIT key during
operation (when the current item to edit is shown) or using the MENU key.
Note: Setting the hold time to 00.0 seconds for any of the above hold times will disable that function of the
display. This is useful at times when only one temperature format will be used.
An option to set relative humidity (RH) is available on the DM-100 controller, but cannot be read using the
standard temp/light sensor.
LED Screen Action
+00 shows the current degrees Celsius temperature offset. Press the
Up and Down Arrow keys to modify the temperature offset.
Only values between -9 and +9 are allowed
Press the ENTER key to accept changes.
Press the CLEAR key to cancel changes.
Press the CLEAR key twice to exit the menu.
Press the ENTER/EDIT key to modify the current attribute listed on the
screen.
°C TEMP OFFSET
ENTER TO EDIT
°C TEMP OFFSET
+00 ↑↓
LED Screen Action
Select the hold time in seconds, and adjust the selection of 12-hr or
24-hr time.
For temperature, choose: XXº, XXF, XX (blank) for Fahrenheit temps
and XXº, XXC, XXc and XX (blank) for Celsius temps [XXº is the
default for ºF, and XXc is the default for ºC].
TIME - 12HR - 6 COL ↑
HOLD 00.0 SEC
°F - FORMAT XX°
HOLD SS.T SEC
°C - FORMAT XXc
HOLD SS.T sec