Daktronics DataTime DF-1012 Time & Temperature Display - Manual (Page 34)

30 DM-100 Controller
The above example is for use with a 12-hour format, the same process will be used for the 24-hour format,
and time will be entered in military time.
After setting the time you will need to set the date. If the date is already correct, enter through the date and
press to send the time to the display. If the date is not correct, follow the steps below.
Set Date
Use the set date menu to enter the date in the display.
Degrees F Temperature Offset
Use the Set ºF Temperature Offset menu to set the degrees Fahrenheit offset temperature. This is the value (in
degrees) that the display will automatically increment or decrement the Fahrenheit temperature value read
from the temperature sensor.
LED Screen Action
MM – Current month
DD – Current day
YY – Current year (last two digits)
Input the month (MM) using the number keys.
Press Enter to move to DD. Enter the day.
Press Enter to move to YY. Enter the appropriate year.
Note: The flashing asterisk on the LCD shows the current data being
edited.
When finished inputting today’s date, press Enter to send to the
display and continue to the next screen.
SET TODAY’S DATE
MM/DD/YY
MM/DD/YY
ENTER TO SEND
LED Screen Action
°F TEMP OFFSET
ENTER TO EDIT
+00 shows the current degrees Fahrenheit temperature offset. Press
the
Up and Down Arrow keys to modify the temperature offset.
Only values between -16 and +16 are allowed
Press the ENTER key to accept changes.
Press the CLEAR key to cancel changes.
°F TEMP OFFSET
+00 ↑↓