750at – Cybex 750AT Arc Trainer User Manual
Page 30
Cybex Arc Trainer 750A/750AT Owner’s Manual
30
Place right handle assembly in position and slide pivot pin back in place.
3.
Screw/Loctite
Washer
Pivot Pin
#21
(Both Sides–Left Side Shown)
750AT
Secure handle assembly with the screws and washers removed in step two of
4.
Remove left and
right handles. Refer to the above diagram.
Locate right linkage rod, right handle assembly,
5.
linkage rod cap 2.00 OD (#20), flange spacer
(#17), SHCS .250-20 UNC-3A SS (#19), and flat washer .281 ID x .500 OD x .062 T (#18). Refer
to diagram at top of page.
Place a drop of threadlocker (#21) on each
6.
SHCS .250-20 UNC-3A SS (#19) and another drop
inside the shaft into which the SHCS will be tightened.
Secure linkage rod to handle assembly with linkage rod cap
7.
2.00 OD
(#20),
flange spacer
(#17),
SHCS
.250-20 UNC-3A SS
(#19) and
flat washer .281 ID x .500 OD x .062 T
(#18). NOTE: The SHCS .250-20
UNC-3A SS (#19) must be tightened to a minimum of 90 in/lbs.
(Both Sides–Left Side Shown)
#20
#17
#18
#19
Loctite
(#16)
NOTE: The
SHCS .250-20 UNC-3A SS
(#19)
must be tightened to a minimum
of 90 in/lbs.
750AT