Cybex 750AT Arc Trainer - Manual (Page 27)

Cybex Arc Trainer 750A/750AT Owner’s Manual
27
Slide pivot pin out, remove right handle assembly and set aside. 4.
Using a 7/32” Allen wrench (#15), remove the screws and washers from the left handle assembly. 5.
Refer to the above diagram.
Verify left handle assembly is mounted on the right side.
6.
Slide pivot pin out, remove left handle assembly and set aside. 7.
Install the left handle assembly
Position the left handle assembly in the correct position on the left side where the right handle 1.
assembly was removed in step 4 of Remove left and right handle assembly .
Screw/Loctite
Washer
Pivot Pin
#21
(Both Sides–Left Side Shown)
750AT
Apply loctite (#16) 2. to threads inside the arm and both screws removed in step 2 of Remove left
and right handle assembly.
(Both Sides–Left Side Shown)
#20
#17
#18
#19
Loctite
(#16)
NOTE: The SHCS .250-20 UNC-3A SS (#19)
must be tightened to a minimum
of 90 in/lbs.
750AT