Comtech EF Data CRS-120 - Manual (Page 25)

1:1 Redundancy Switch Revision 3
Installation MN/CRS120.IOM
2–3
2.2.2 CRS-120L Optional Mounting Panel
An optional mounting panel (KT/11362-2) is available to attach the 1:1 redundancy switch to the
standard 19-inch cabinet. Install Mounting Panel as follows:
1. Remove two bottom switch screws (Figure 2-2) and set a side.
2. Remove the two upper switch screws and discard.
3. Remove grounding nuts and washers from grounding lug and set aside.
4. Position mounting panel onto switch.
5. Reinstall gounding nuts and washers previously removed.
6. Reinstall two bottom switch screws previously removed.
7. Install two kit screws (component of KT/11362-2) and secure.
Figure 2-2. CRS-120L Optional Mounting Panel
Optional: Mounting Panel
Kit Screws
(Typical 2 Places) Grounding Lug Nuts and Washers
Switch Screws
(Typical 2 Places)