Comtech EF Data CRS-120 - Manual (Page 23)

2–1
Chapter 2. INSTALLATION
2.1 Unpacking
The switch and manual are packaged in pre-formed, reusable, cardboard cartons containing foam
spacing for maximum shipping protection.
CAUTION
Do not use any cutting tool that will extend more than 1 inch into the
container. This can cause damage to the modem.
Unpack the switch as follows:
1. Cut the tape at the top of the carton indicated by OPEN THIS END.
2. Remove the cardboard/foam space covering the switch.
3. Remove the switch, manual, and power cord from the carton.
4. Save the packing material for storage or reshipment purposes.
5. Inspect the equipment for any possible damage incurred during shipment.
6. Check the equipment against the packing list to ensure the shipment is correct.
2.2 Mounting
The 1:1 redundancy switch is designed to be connected and self-supporting at the rear of the two
modulators. The two alarm cables provide this support, but in most rack installations additional
support is usually provided by physically anchoring the connecting cables.