Comtech EF Data M&C Software for Windows - Manual (Page 26)

Monitor and Control Software for Windows Revision 4
Operation MN/M-CWIN.IOM
2–10
2.4.1 Status Screen
The Status Screen (Figure 2-10) reports faults, frequencies, attenuation values, and
redundancy parameters. The screen takes on different forms depending upon the
configuration (see Section 2.1.1.3). Shown below is the screen for a single thread system
supporting one KST-2000A unit.
Figure 2-10. Status Screen
All text boxes are gray unless the MODIFY button is clicked. This causes the user-
modifiable fields to be highlighted in yellow. Changes can be made to those highlighted
areas. Click the CANCEL button to restore the original values. If the SEND button is
clicked, those data fields which have been modified are transmitted to the associated RF
terminal. During transmission, if an entered parameter falls outside of the allowed values
for that command, the word ERROR appears briefly highlighted in red. For both the