beautypg.com

Hearth access and assembly, Operating fireplace, Continued – Desa (V) CD36R(N User Manual

Page 25: Manual ignition system

background image

25

www.desatech.com

116035-01B

HEARTH ACCESS AND ASSEMBLY (Cont.)

Installing Logs and Glowing Embers

OPERATING FIREPLACE - Manual Ignition System

For Your Safety Read Before Lighting

HEARTH ACCESS AND ASSEMBLY

Continued

INSTALLING LOGS AND GLOWING EMBERS

A 4 piece ceramic log set comes packed inside the unit firebox.

Removal of glass door is necessary to unpack and assemble the logs

and add hearth treatments. Follow steps under Removing/Replacing

Glass Door, page 24 to access the logs and burner.
Assemble the logs and add burner treatments as follows:
1. Position the base log onto burner log mounts. (see Figure 56).

Note:

The cut out on the bottom should fit over the mounts

and the base log should be positioned against the rear panel

2. Position the holes on the bottom of the rear log over the pins

on the base log Figure 53).

3. Position the top left log and top right log onto the rear log

and base log as shown in (see Figure 54).

BURNER

PAN

REAR
PANEL

REAR LOG

STAND

LOG

MOUNTS

REAR

LOG

TOP
RIGHT
LOG

TOP
LEFT
LOG

Figure 56 - Installing Logs

4. Open the bag of ember materials.
5. Break apart about quarter sized pieces and place about a

single layer along the full length of the ember tray to hide

the bottom edge of the base log. (see Figure 57).

6. Replace the glass door and louver panels. See Removing/

Replacing Glass Door, page 24.

WARNING: The glass door must be securely in

place before running this fireplace. Do not run this
fireplace if glass is missing or broken.

Figure 57 - Applying Ember Material

OPERATING FIREPLACE

Manual Ignition System

FOR YOUR SAFETY READ

BEFORE LIGHTING

WARNING: If you do not follow these instructions

exactly, a fire or explosion may result causing prop-
erty, damage, personal injury or loss of life.

A. This appliance has a pilot which must be lighted by hand.

When lighting the pilot, follow these instructions exactly.

B. BEFORE LIGHTING smell all around the appliance area

for gas. Be sure to smell next to the floorbecause some gas

is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electric switch; do not use any phone

in your building.

• Immediately call your gas supplier from a neighbor’s

Phone. Follow the gas supplier’s instructions.

EMBER

MATERIAL

EMBER

TRAY