Compuprint SP40 plus - Manual (Page 44)

User Manual
MAN10239-01 39
Paper Specifications
The documents must all guarantee the following characteristics:
o Use paper matching the indicated characteristics.
o They must have well defined top and left edges, with a square angle tolerance of 0.1° on all edges.
o Paper
with holes, perforations, folds or tears anywhere within the print area of the document cannot
be feeded from the front input chute, but could be eventually managed by the rear tractor requesting
the specific Compuprint SP40plus model.
o The radius on a corner of the form must be within 9.5 mm from the left or right edge.
o The form to be printed must not contain foreign material.
o Form
opacity must be at least 75%. Forms with a lower opacity may cause feed errors.
o Never print on documents with metallic or hard plastic fasteners or staples, they may damage the
printer. Use only sewn passbooks.
o To get the maximum print contrast you should print on white or light colored paper. You may
overstrike to improve the low contrasting paper.
o It is preferable to use single and multiple documents with the fibre running in the insertion direction of
the printing unit.
o Recycled paper is permitted on principle.
o It is preferable to print on multiple forms with a narrow glue strip or top-gluing. The gluing must not
cause waving in the set of forms.
Cuts Sheets
Insertion direction
Print Area
A
B
C C
D
E
Dimensions Maximum Minimum
A Form width 244 mm (9,606 in.) 65 mm (2,559 in.)
B Form length 470 mm (18,50 in.) 65 mm (2.559 in.)
C
Distance between dot position and left or
right paper edge
- 3.0 mm (0,1181 in.)
D
Distance between top of the first printed
line and top margin of the document
- 1 mm (0.0394 in.)
E
Distance between the lower margin and
the lower part of the last printed line
-
5.8 mm (0..2283 in.)
Reduced to 1.5 mm (0.0591 in.) with
item SAFE BOTTOM EDGE = no
Weight (original) 200 g/m 2
40 g/m 2
With paper <60 g/m 2 set the item
PASSBOOK TYPE = horizontal
Weight
(original + 1 to 6 copies)
1 st 75 g/m 2
other 75 g/m 2
carbon 35 g/m 2
1 st 55 g/m 2
other 45 g/m 2
carbon 14 g/m 2
Single form media up to 0,65 mm (0.0256 in.)
Thickness
Multi form media up to 0.65 mm (0.0256 in.).
Overall thicker than 0,35 mm (0.0138 in.) may cause print quality
degradation in last copy.