Compuprint SP40 plus - Manual (Page 38)

User Manual
MAN10239-01 33
Write NVM
After reading the configuration, it is possible to do all the possible changes simply select the new values.
When all modification are done, the new configuration can be stored in the printer NVM pressing the Write
NVM action key.
The utility will show the “save as name” mask.
The new configuration can be saved in a specific file and path (default name is wnvm.dmp and default path
is where the SP40Setup utility is stored) to be used for future configuration with a simply copy file action.
After that the printer will reboot.
The configuration file.dmp can be simply used to duplicate the same configuration on more printers.
SP40plus unit has to be powered on in normal mode, connected to the PC through any active interface
(Centronics or Serial port) and prompt:
copy file.dmp lpt1: /b
command from a DOS shell,
After that the printer will reboot.
Send Setup
When Send Setup action key is activated, the host will displayed the stored configuration files.dmp; select
one and then click on open to immediate send it to the printer.
After that the printer will reboot.
Restore MFG
If the restore of the manufacturing values must be done, press the proper key: all the parameters will
be set immediately to the default values.
After that the printer will reboot.