Compuprint SP40 plus - Manual (Page 16)

User Manual
MAN10239-01 11
Leds
LED NORMAL MODE SETUP MODE SPECIAL MODE
Lit if paper presence, Unlit without paper
(no Olivetti).
When using the IBM 4722, IBM 9068 and
the Olivetti protocols in two operators
(“booking”) mode, the ST1 led is under
software control. If the printer is in Setup
Mode, this led indicates
which setup page is
selected for printing. See
“
Printer Setup ” later in this
manual.
Blinks, together with the
ST2 led, if a printer error
occurs. See “
Error
Message ” later in this
manual.
Lit, when the printer is ready (on line).
Unlit, when the printer is in local (off line).
If the printer is in Setup
Mode, this led indicates
which setup page is
selected for printing. See
“
Printer Setup ” later in this
manual.
On, if the printer is powered on without
data.
Off, if the printer is powered off.
Blinks if the printer has data traffic or data
in the buffer. Blinks if the printer is in
Setup Mode. See “
Printer
Setup ” later in this
manual.
Lit when the Letter Quality print mode is
selected. Unlit when the Draft printmode is
selected.
When using the IBM 4722, IBM 9068 and
the Olivetti protocols in two operators
(“booking”) mode, the S2 led is under
software control. If the printer is in Setup
Mode, this led indicates
which setup page is
selected for printing. See
“
Printer Setup ” later in this
manual.
Blinks, together with the
ST1 led, if a printer error
occurs. See “
Error
Message ” later in this
manual.
LCD display messages (only for the model with it)
Upper line message
Lower line message
Indication
STARTING UP The printer initialization phase is starting-up.
..INIT.. The printer initialization phase is ended
SP40plus Rel. xxx The printer firmware release message
PRINTER READY
PROG1 DRAFT
The printer is in normal ready status showing the current Program and the current Font.
PRINTER READY
HEX-DUMP MODE
The printer is in normal ready status in hex dump mode.
PRINTER OFF-LINE
PUSH ON LINE
The printer is in off-line status.
PAUSE ON PRINT
PUSH ON LINE
The printer is going in off-line status while data are in the buffer and ready to be printed.
WAITING MEDIA
INSERT MEDIA
Data are sent to the printer, the printer is waiting for the insertion of the paper.
PRINTER BUSY
EPSON PARALLEL
The printer is currently printing showing the used Emulation and interface
SET UP
The printer is in Set Up status and is waiting for a blank sheet to be loaded
See “
Printer Setup ” later in this manual.
SETUP PAG=CONF
ST1=PAG ST2=PRT
The printer is waiting for a Set Up operation selection.
See “
Printer Setup ” later in this manual.
NVM CHANGED
The firmware of the printer has been updated and the NVM values have been resored to
the default parameters.