Compuprint SP40 plus - Manual (Page 36)

User Manual
MAN10239-01 31
SP40Setup utility installation
Once the Compuprint CDC RS-232 Emulation driver has been installed, found the Setup.exe file and double
click on it.
Follow the steps displayed in the below masks in order to correctly install the utility.
The utility will ask where install the program and choose the program group.
If the installation is positively ended, in the program pop-up window, the SP40Setup icon will appear.
Double click on it and the SP40Setup utility will be run.
See next chapter for details.
Remote Setup
When this utility is running, the following home mask will be displayed.
In the left top side, under Option, there is the choice of the SP40 and SP40plus Program Setup selection.
In the right to side there are the following selection window:
1) port selection choice COMn (*)
The following action keys:
2) NVM choices for Read, Write, Send Setup, Restore MFG and Exit from Setup for Setup Parameters
3) Refresh List Interfaces
4) Load
FW
5) Other selection keys are currently disables (Reboot and USB ID).