Compuprint 6314 CDL - Manual (Page 20)

CDL – Programmer Manual
20
1: rotation by 0°
38
2: rotation by 90° clockwise
3: rotation by 180° clockwise
4: rotation by 270° clockwise
b indicates the type of object. It may be
X: geometric figures
0-9: alphanumerical fields (see sect. 2.2.1 on page 21)
A-O (a-p
39
): bar codes (see sect. 2.2.2 on page 28)
Y: graphic images
cd are the horizontal (c) and vertical (d) expansion coefficients; for bar codes it is the ratio.
They may be:
11: for the geometric figures
1-9 and A-O: for the alphanumerical fields
1-9 and A-O: for the bar codes
40
1-9 and A-O: for the graphic images
eee have the following meaning
000: for the geometric figures
000: for alphanumerical fields from 0 to 8 (b=0-8)
001-010: for the alphanumerical field 9 (b=9)
000-999: for bar codes (this is the height in hundredths of an inch
41
)
000: for the graphic images
ffff is the line co-ordinate in hundredths of an inch
42
for the bottom left corner of the object (starting
from the lower edge of the label).
gggg is the column co-ordinate in hundredths of an inch
43
for the bottom left corner of the object
(starting from the left edge of the label). The bottom left corner of the label is identified by
co-ordinate 0000, 0000.
nn...n is the contents of the object.
For geometric figures it may be:
L hhh iii: L indicates that it is a line, hhh is the width in hundredths of an inch
44
, iii is
the height
l hhhh iiii: hhhh is the line width, iiii is the height
38
For geometric figures and graphic images, it is assumed that the rotation is always 1 whatever value is set.
39 When the bar code type is identified with an upper-case letter, whatever is coded in it appears decoded below it; when
the letter is lower-case no decoding appears under the bar code.
40 For specific bar codes (see sect. 2.2.2 on page 28) large and small bars must be in precise ratio so that the code may
be reliably read.
41
After an m (see sect. 2.1.2.1.1 on page 13), this is the height in tenths of a millimetre.
42
After an m (see sect. 2.1.2.1.1 on page 13), this is the line co-ordinate in tenths of a millimetre.
43
After an m (see sect. 2.1.2.1.1 on page 13), this is the column co-ordinate in tenths of a millimetre.
44 After an m (see sect. 2.1.2.1.1 on page 13), this is the line width in tenths of a millimetre.