Compuprint 6314 CDL - Manual (Page 13)

CDL – Programmer Manual
13
n Present sensor Cutter
0 Disabled Disabled
1 Disabled Enabled
4 Enabled Disabled
5 Enabled Enabled
e.g. STX V4 enables the present sensor and disables the cutter.
STX v - RS 232 port configuration
It prints the configuration of the RS 232 port as it appears on the test label.
STX Xa – Current drive
With this command you can select the current drive C (see i commands STX Iafnn...n and
s(A/B/C/D/E)nn...n) as the volatile RAM memory (a=A) or as the non-volatile flash memory (a=B,
D o E)
19
.
e.g. STX XA selects drive C as the volatile RAM memory.
STX Z – Print test and configuration
It prints the configuration and the test label in the same way as when you press the ON-LINE and
FEED buttons when the printer is switched on (for further information, see the user’s manual for the
printer used) without, however, going into dump mode..
2.1.2.1 Label definition commands (STX L)
They are included between the STX L and the E (or X or s(A/B/C/D/E)nn...n) commands. They are
not generally preceded by any particular character (neither STX or SOH) and “end” with the CR
20
character.
2.1.2.1.1 Local setting commands
These commands permit you to set a number of local label parameters like temperature, print speed
and label quantity.
:nnnn – Cut command
Like the cnn command below (see), nnnn is the number of labels printed before the cutter operates
(if it is fitted and enabled). Unlike the cnn command which can contain only two digits, this
command accepts up to four digits.
19
The default current drive is B. The A when the RAM is installed (in an expander card). Drives A, D and E are
available only on expander cards.
20 The line terminator can be replaced, in label definition mode, by another character with the command T (see sect.
2.1.2.1.1 on page 13) which is a local command and therefore is valid only for the current label.