Compuprint 6314 CDL - Manual (Page 17)

CDL – Programmer Manual
17
a Speed (ips
28
)
A 2
B 2
C 2
D 2,5
E 3
F 3,5
G 29 4
H 4,5
I 5
J 5,5
K 30 6
L 6,5
M 7
N 7,5
O 31 8
e.g. with command pG, the paper returns, if a backfeed has been set (see command STX fnnn), at a
speed of 4 ips.
Qnnnn – Quantity of labels to be printed
nnnn indicates the number of times you wish to repeat the current label.
e.g. with Q0030, the current label is printed 30 times.
Rnnnn – Vertical offset (of lines)
Just as you can set a “local” horizontal offset (see command Cnnnn), you can also set a vertical one
(positive) in which nnnn are the four digits that quantify the amount of the offset.
e.g. R0015 adds 15 to all the line co-ordinates and the label appears longitudinally offset 15
hundredths of an inch
32
higher.
rnn...n – Retrieve saved label
You can save the current label using the command s(A/B/C/D/E)nn...n and later retrieve it with this
command.
nn...n is the name of the label to be retrieved.
Sa – Select paper advance speed
With this command you can select the label advance speed during the “not printing” phase: that is
the speed at which the paper advances once the actual printing has been done.
Since this is a label definition command, it is local.
a can be set at the following speeds:
28
Inches per second.
29
Default and max. speed.
30
Default speed for models with expander card .
31 Max. speed for models with expander card.
32 After an m (see relevant paragraph), 15 tenths of a millimetre.