Compuprint 6314 CDL - Manual (Page 15)

CDL – Programmer Manual
15
D11
D12
D21
D22
23
D31
D32
fig. 2 – Dot sizes
The effect is that all the objects on the label can be expanded horizontally and/or vertically using
only one command.
D11 gives the highest resolution (on this subject, see the user’s manual for the printer used).
E – Label definition mode terminator
On receiving this command, the printer prints the current label and exits the label definition mode.
G – Register memory
The field preceded by this command is saved in the first free register. The registers are filled in
succession from A to Z and their value is retrieved with the command STX Sn, see relevant
paragraph.
In practice each field is saved in registers A-Z even without using the command G: the registers are
filled in succession starting from the first alphanumerical field of the label definition commands.
The current G command only makes the memorisation explicit, highlighting it.
Hnn – Head temperature
To achieve optimum print quality, it may be necessary to modify the default temperature set with
the HEAD TEMPER. SELECTION parameter (on this subject, see the user manual for the printer
used) using this command Hnn. For this purpose, nn may vary from 00 to 20. The optimum
temperature depends on the type of ribbon and on the type of surface: as an indication, you should
start with a temperature of 10 increasing it until you find the one that gives the best results.
23 Default setting.