Compuprint 6314 CDL - Manual (Page 12)

CDL – Programmer Manual
12
STX Sn – Feed speed
The paper advance speed can be selected by pressing the FEED button. The n (from A to O)
corresponds to the following table:
n Speed (ips 15 )
A 2
B 2
C 2
D 2,5
E 3
F 3,5
G
16
4
H 4,5
I 5
J 5,5
K
17
6
L 6,5
M 7
N 7,5
O 18 8
e.g. After entering STX SG, the feed speed is 4 inches per second.
STX T – Print test
It prints a test label like the one printed by pressing the ON-LINE and FEED buttons when the
printer is switched on (for further information, see the user’s manual for the printer used) without
going into dump mode and without printing the configuration.
STX Unnss...s – Fill register
It fills register nn (two-digit number) with the alphanumerical string ss...s (which must end with
CR). The string ss...s may differ in length from the one previously saved in register nn.
STX Vn – Enable cutter and present sensor
According to the number given at n the cutter or the present sensor are enabled/disabled as in the
following table:
15
Inches per second.
16
Default and max. speed.
17
Default speed for models with expander card .
18 Max. speed for models with expander card .