Belshaw Adamatic Snack Master Snack Food Frying System - Manual (Page 35)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Snack Master TS MN-xxxxEN 13
THE ELEMENT WILL NOT HEAT, AND THE CONVEYOR WILL NOT RUN.
Possible Causes What To Do
The power cord is not plugged in, or the outlet
has no power. Connect the machine to a good power source.
WARNING
To avoid being burned, electrocuted, or otherwise
injured, before doing any of the following, turn
off the machine, allow the shortening to cool, and
disconnect the machine from the power source.
The power cord is defective. Replace the power cord.
THE ELEMENT WILL NOT HEAT, BUT THE CONVEYOR RUNS.
Possible Causes What To Do
The high temperature limit control switch has
been tripped. Push the red reset button on the back panel of the
heater head.
The thermostat has been calibrated incorrectly. Recalibrate the thermostat.
WARNING
To avoid being burned, electrocuted, or otherwise
injured, before doing any of the following, turn
off the machine, allow the shortening to cool, and
disconnect the machine from the power source.
The high temperature limit control is defective. Replace the high temperature limit control.
The thermostat is defective. Replace the thermostat.
The contactor for the heating is defective. Replace the contactor.
The connections to the contactor are bad. Rewire the connections to the contactor.