Belshaw Adamatic Snack Master Snack Food Frying System - Manual (Page 28)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
6 MN-1013EN Snack Master TS
WARNING
To avoid being burned, electrocuted, or
otherwise injured, always unplug the
machine and allow it to cool down before
making adjustments, clearing obstructions,
lubricating, cleaning, or disassembling.
Lubricating
Daily
Before using the machine each day, inspect the
upper and lower conveyors for damage.
Figure 2-1. Lubricating the Connecting Rod.
Weekly
1. Remove the heater head cover and lightly
coat the gear teeth with multi-purpose
grease. Replace the cover. See Figure 2-1.
Figure 2-1. Lubricating the Drive Gears.
Yearly
Lubricate the conveyor drive motor as explained
below. To help you better understand where to
lubricate, refer to the Parts Drawings.
1. Disconnect the machine from the power
source.
2. Remove the back cover of the heater head.
3. Unscrew the two bolts that connect the
conveyor drive assembly to the bottom of
the heater head.
CAUTION
Be gentle with all parts of the conveyor
drive assembly, especially when pulling the
assembly out of the heater head and
putting it back in the heater head..
Damaging the parts could stop production.
4. Carefully pull the motor out of the heater
head. See Figure 2-3.
Figure 2-3. Removing the Conveyor Drive
Motor.