Belshaw Adamatic Snack Master Snack Food Frying System - Manual (Page 12)

Belshaw Bros., Inc.
• www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
6 MN-xxxxEN Snack Master OM
WARNING
All parts must be dried thoroughly.
Moisture causes hot shortening to spatter,
which may cause serious injury.
4. After the shortening has drained off of the
conveyor assembly, set the conveyor
assembly aside.
9. Check again to see that the shortening in the
kettle has cooled to 100
°F/38°C.
10. Remove the shortening from the kettle using
one of these methods:
• Using the drain valve, drain shortening
into optional EZ-Melt Shortening filter.
• Using the drain valve, drain shortening
into metal bucket. The method will
require some means to remove
impurities from the shortening
• Using a small saucepan or a metal
pitcher, scoop as much of the shortening
as you can into one or more large metal
buckets. Then lift the kettle out of the
fryer case and carefully pour the rest of
the shortening into a metal bucket. Be
careful not to disturb the sediment that
has accumulated in the bottom of the
kettle.
WARNING
Do not use plastic buckets for shortening
storage. If the shortening is not cool
enough, the buckets will melt; possibly
causing you to be burned, and causing
shortening to get on the floor.
WARNING
Do not allow the shortening to overflow the
buckets. Shortening will get on the floor,
and if the shortening is not cool enough,
you may be burned.
WARNING
Thoroughly clean and dry the floor if
shortening is spilled. Shortening on the
floor can cause serious injury or loss of life.
11. Return the kettle to the fryer case, if you
have removed it.
12. Tilt the heater assembly down.
13. Brush off any carbon that has accumulated
on the heating element. Accumulated
carbon can cause corrosion and ineffective
heating.
14. Tilt the heater head assembly back, raising
the heating element out of the kettle.
15. Lift the kettle out of the fryer case. Remove
and dispose of the remaining shortening and
the accumulated sediment. Dry the outside
of the kettle.
16. Put the kettle back in the fryer case.
17. Tilt the heater head assembly down.
19. Install the conveyor assembly.
Washing
1. Pour hot water into the kettle, up to the
normal level of the shortening. Add about
2 oz/59 ml of trisodium phosphate or other
appropriate cleaner.
2. Connect the machine to the power source.
Heat the solution to 200
°F/93°C. Turn on
the conveyor. Keep the solution at this
temperature for 15-20 minutes.