Belshaw Adamatic Snack Master Snack Food Frying System User Manual
Page 34
Belshaw Bros., Inc.
• www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
12
MN-1013EN
Snack Master TS
THE CONVEYOR IS JAMMED.
Possible Causes
What To Do
WARNING
To avoid being burned or otherwise injured,
before doing any of the following, turn off the
machine and allow the shortening to cool.
Cooked food particles are wedged between a
chain opening and a sprocket tooth.
Clean to remove the food particles. Clean the Snack
Master regularly and thoroughly.
The conveyor drive shaft and the drive motor
shaft are out of alignment.
Remove the cover of the drive assembly. Loosen the
four mounting spacers so the drive assembly can be
moved. Align the motor shaft with the conveyor
shaft. When they are aligned, tighten the mounting
spacers. Replace the cover.
THE MOTOR OVERHEATS.
Possible Causes
What To Do
The power requirements of the machine do not
match the power source.
Supply the correct power as specified on the data
plate.
WARNING
To avoid being burned, electrocuted, or otherwise
injured, before doing the following, turn off the
machine, allow the shortening to cool, and
disconnect the machine from the power source.
The motor is binding.
Repair or replace the motor.
The motor is defective.
Repair or replace the motor.