BECKHOFF CX2100­09x4 - Manual (Page 29)

Transport
3 Transport
3.1 Unpacking, installation and transport
Dimensions and weight of the individual modules:
CX2100­0904:
Dimensions (W x H x D): 118 mm x 100 mm x 91 mm
Weight: approx. 1025 g (system interface)
CX2100­0914:
Dimensions (W x H x D): 118 mm x 100 mm x 91 mm
Weight: approx. 695 g (system interface)
The specified storage conditions must be adhered to (see "Technical data").
Unpacking
Proceed as follows to unpack the unit:
1. Remove packaging.
2. Do not discard the original packaging. Keep it for transporting the device in the future.
3. Check the delivery for completeness by comparing it with your order.
4. Please keep the associated paperwork. It contains important information for handling the unit.
5. Check the contents for visible shipping damage.
6. If you notice any shipping damage or inconsistencies between the contents and your order, you
should notify Beckhoff Service.
Attention
Danger of damage to the device!
During transport in cold conditions, or if the device is subjected to extreme temperature dif­
ferences, condensation on and inside the device must be avoided. Prior to operation, the
device must be allowed to slowly adjust to room temperature. Should condensation occur,
a delay time of approximately 12 hours must be allowed before the unit is switched on.
Installation
The devices are designed for installation in control cabinets.
Shipping and relocation
Despite the robust design of the unit, the components are sensitive to strong vibrations and impacts. During
transport, your computer should therefore be protected from excessive mechanical stress. Therefore, please
use the original packaging.
CX2100­09x4 29 Version 1.1