Basler Electric IDP-800 User Manual
Page 40

34
9437600990 Rev F
Capability
The Capability screen (Figure 40) is accessed by pressing the Capability button on the DECS Metering
screen. By default, a horizontal curve is displayed. Pressing the Vertical Curve button selects a vertical
curve orientation.
Figure 40. Capability Curve Screen
If a plot of the underexcitation limiter (UEL) curve is desired, the UEL Selection button can be pressed to
access the UEL Curve Selection screen (Figure 41). Here, the internal DECS UEL curve can be selected
or a customized, three-point, four-point, or five-point curve can be selected and configured. UEL curve
points must be selected in BESTCOMSPlus
® software for an accurate representation on the
IDP-800. Pressing the None button disables the display of UEL curves.
Figure 41. UEL Curve Selection Screen
Analog Metering
Analog representations of the digital metering values shown on the DECS Metering screen (Figure 38)
can be accessed by pressing the Analog Meter button. Pressing this button accesses the Generator
IDP-800-C Operation
IDP-800