Using the elle tens+ in pelvic mode, Adjusting your intensity level, After use – Babycare TENS Elle TENS User Manual
Page 30

Display
Using the Elle TENS+ in PELVIC mode
Do not exceed treatment times unless advised by a medical professional.
Adjusting your intensity level
Begin by pressing the CH1+ key. Each time you press this key, you will see the
intensity level increase on the LCD.
Carefully continue to press CH1+ key until you comfortably feel your muscles
contracting. If the sensation feels too strong, simply press the CH1- key to
minimise the intensity.
The programme’s remaining time is shown in the display.
After use
Your Elle TENS+ will automatically switch off once the programme is
complete. After use, always remember to ensure that the Elle TENS+ is
switched off. Remove the Elle TENS+ probe from your body and disconnect
the leads. Clean the probe with warm running water but do not soak. Rinse
all soap and residue from probe. Dry with a clean cloth/paper towel and
allow to air dry.
+
CH1
CH1
30
Important
• The Vaginal Probe is single
patient use only. Additional
probes and gel can only be
purchased from Body Clock.
• Probes may be re-used by the
same patient only.
• Wash probe as instructed
before each use.
• Do NOT use the probe if the
pack is open or damaged.