Babycare TENS Elle TENS - Manual (Page 10)

Press Display
Using the Elle TENS+ in BIRTH mode
+
Opti
Max
Mode
+ CH1
BIRTH
10
Entering BIRTH mode
a). You are now ready to use your Elle TENS+. Ensure that the Boost Button
located at the top right of the unit is not pressed in. Switch the unit ON by
pressing the On/Off Button. You will see ‘BIRTH’ flashing in the top left
corner of the display.
b). Press Mode to confirm ‘BIRTH’ mode, otherwise your Elle TENS+ will
automatically enter the BIRTH mode after a few seconds.
c). If the unit does not already display ‘BIRTH’ (i.e. PAIN or PELVIC is flashing),
use the Opti-Max Key to cycle through the modes, until ‘BIRTH’ is flashing.
N.B. Your Elle TENS+ always starts up in the mode used previously.
To select another mode you must first turn off the unit and follow the
instructions as above.
Adjusting intensity for pain relief during labour
Begin by pressing the CH1+ key. Each time this key is pressed, ‘half-moons’
will appear on the screen increasing in number and size as the intensity is