Babycare TENS Elle TENS - Manual (Page 20)

Display
Using the Elle TENS+ in PAIN mode
Entering PAIN mode
a). Switch the unit ON by pressing the On/Off Button. Note that your Elle TENS+
will always start up in perviously used mode. You need to select ‘PAIN’.
b). If the unit does not already display ‘PAIN’ press the Opti-Max Key to cycle
through the 3 available modes, (BIRTH, PAIN, PELVIC) until ‘PAIN’ flashes at
the top of the display as shown in the diagram.
c). Press the Mode Button to confirm ‘PAIN’ mode, otherwise your Elle TENS+
will automatically enter PAIN mode after a few seconds. To select another
mode you must first turn off the unit and follow instructions as in a) above.
Adjusting intensity for pain relief
Begin by pressing the CH1+ key. Each time this key is pressed, ‘half-moons’
will appear on the screen increasing in number and size as the intensity is
increased. You will begin to feel a tingling sensation. Press CH1- should you
wish to reduce the intensity.
20
+
Opti
Max
Mode
+ CH1
Press