Avery Dennison 9850 Addendum Version 2.0 - Manual (Page 17)

17
6. Press r to display “Yes” and press Enter/Pause. You will see
CREATING FLASH
FILE SYSTEM 1
7. The SIMM board OR the printer’s flash memory is cleared and reformatted.
This process may take several minutes.
The printer reboots automatically after formatting flash memory. You need
to resend any fonts you want to save in flash memory again.
When you format flash memory, ALL fonts saved in the
printer’s flash memory OR on the SIMM board are deleted.
You will see
Print Mode
Ready
Using an Immediate Command:
Your System Administrator can send the ^FF immediate command to format the
SIMM board, clear the printer’s flash memory, or check the amount of free memory
left in either the printer’s flash memory or on the SIMM board.
Command Description
^FF1 Formats flash memory (either in the printer or the
optional SIMM board)
^FF2 Returns the amount (in bytes) of free memory in flash
When the printer is first turned on, immediate commands are not available. To use
these commands, your System Administrator must first send the control characters
packet and define the immediate command control character.
Once the immediate command control character is defined, the immediate
commands are enabled. For more information about immediate commands, refer to
the optional Packet Reference Manual available on our Web site
(www.monarch.com) or order a printed copy (part number TC9800PM).