Avery Dennison 9460IP - Manual (Page 7)

7
Setting the Power Save Mode
1. Select the Power Save
mode by checking the
Enable box from the Card
Configuration screen.
2. Set the Algorithm to a
value between 1 and 10
(for 802.11b) or 1 and 11
(for 802.11). 1 is the
shortest sleep time (uses
battery power quicker, but
responds faster); 10 is the
longest sleep time (optimal
battery conservation, but
responds slower).
For an 802.11 radio, if you
select 11, you must set the
Beacon Minimum and
Beacon Maximum values.
These values are not used for 802.11b radios.
If the Power Save mode is not enabled, the device operates in CAM
mode (constantly awake). CAM means the printer is continuously
receiving and transmitting data. This mode uses battery power
quickly.
Do not use the Micro AP Mode, Operation Options, or
Communication Settings. Changing any of these values
may cause the printer to stop communicating!
Do not change the Manager MAC Address from the Other Parameters
section.