Avery Dennison 9460IP - Manual (Page 11)

11
DHCP Configuration
1. Set the IP Address (Local) to all zeros on the Card Configuration screen.
2. Select the check box for “Enable DHCP.”
3. If you enable the check box “Replace static remote IP with DHCP server
IP,” the current remote IP address is overwritten with the IP address of
the DHCP server.
4. Set the remaining options according to your network.
NOTE: Use extreme caution if you check “Flash DHCP settings upon
response.” If checked, the DHCP settings are flashed and saved.
The next time the device is turned on, it comes up as a Static IP, not
DHCP.
S a v i n g t h e C o n f i g u r a t i o n
1. Click Save to File to save this configuration to a file to use for another
printer. When you use Restore from File, update the IP address, etc. if
needed. (This is optional.)
2. Click Program Card and Exit to program the card with the current
configuration settings on the Card Configuration screen. A message
appears “Ready to update the card. Ok to proceed?” Select Ok or
Cancel to continue.
3. Click Exit when you are finished configuring the printer using the
Configuration Utility.
4. Turn off the printer.
5. Remove the serial cable from the host to the printer’s radio harness.