Avery Dennison 9460IP - Manual (Page 2)

2
S e l e c t i n g t h e P r i n t e r U s i n g a S e r i a l I n t e r f a c e
Before you can use the IP printer, you must configure it. All nodes of a
wireless network need to have the same settings in order to communicate
with each other. For initial printer setup, you must use the serial
interface.
1. Connect a serial cable (DB9 female to DB9 female all lines wired straight
through) from the host or PC to the printer’s radio harness.
2. Turn on the printer.
3. Start the Configuration Utility. Depending on the Configuration Utility’s
version, the screens may appear differently.
4. Select Serial, direct to card.
Radio Harness