Avery Dennison 9460IP - Manual (Page 4)

4
9. Highlight the printer to configure and click Config.
A CAUTION window appears. Read all the information. You can
disable the CAUTION window for this session or permanently. Click
Ok to continue.
10. Follow the steps in “Configuring the RF Interface.”
S e l e c t i n g t h e P r i n t e r U s i n g a N e t w o r k I n t e r f a c e
Follow these steps to select a printer using a network interface or to verify
printers on a network.
1. Turn on the printer.
2. Start the Configuration Utility.
3. Select Network.
4. Click Discover.
Since you are connected through a network interface, multiple
printers may appear.
The Card History Window appears at the bottom of the screen to give
a status of the connected printers. For example, you may see a
message “Card Discovered” when an IP printer is discovered by the
Configuration Utility. Messages also appear when printers are
turned off or disconnected from the network. You can highlight a
printer and Clear Current Card’s History or Clear All Card
Histories.