Avalon Firestyles 1750 Large Pedestal - Manual (Page 4)

Large Pedestal (1750, Olympic)
99200129
Page 4 of 4 12/21/07 © Travis Industries, Inc.
Outside Air Installation – Through the Pedestal into the Crawl Space
This pedestal has an internal air duct that may be used to direct air to the firebox. Outside air is then drawn from
the crawl space under the stove (check with local building codes for requirements in your area). See the
directions below for installation details.
1 Determine the location of the hole placed under the pedestal. The illustration below details the location of the
pedestal in relation to the front of the stove. The hole should be at least 16 square inches.
17"
16"
26"
19-3/4"
Outside air may be drawn
from this area underneath
the pedestal
(min. 16 square inches)
Pedestal Base
(with dowels)
Top View
The faceplate of the Olympic is 1/4" in
front of the forward edge of the
pedestal base.
The faceplate of the 1750 is 2-1/2" in
front of the forward edge of the
pedestal base.
FRONT
2 Attach the included screen over the hole (staples are included with the pedestal). Tuck insulation under both
sides of the pedestal and under the holes in the base of the pedestal (see step “a” on the page 2). This
prevents air from entering under the pedestal.
Staples are used to attach
the screen to the floor.
Screen is used to prevent
rodents from entering.
Insulation is used to seal the side
edges of the pedestal .
3 Attach the stove to the pedestal.