Avalon Firestyles 864TRV GS Blower - Manual (Page 2)

864TRV GS – 564 SS GS
Blower Installation Instructions
(sku 99000162)
Page 2 of 4 17601556 - 9/6/13 © Travis Industries, Inc.
Special Instructions for GreenSmart™ 1 Remote (GS1)
When using the GS1 remote, the rheostat is bypassed and the power connected to the fan extension module.
Disconnect and discard the electrical line that leads from the snap disk to the rheostat (carefully remove the wire tie and
“SNAP DISK” label from the wiring harness – see “a”). Attach the lead from the power input to the snap disk (see “b”). Attach
the wiring harness molex to the power lead (included with the remote – see “c”). Then plug the power lead into the outlet
labeled “FAN” on the fan control module. Disregard the instructions for installing the rheostat (steps 6 through 9) or attaching
power to the wiring harness (step 4).
Installation
1 Remove the concealment cover (see Figure 1).
Figure 1
2 Unscrew the four screws holding the control cover in place (see Figure 2). Carefully remove the control
cover and place it aside (leave the wiring intact - see Figure 3)
Figure 2
Figure 3