ATEIS ECS - Manual (Page 8)

ECS MANUAL
Version EN.1
8
There is also the AEC component which is particular to the ECS. It is this component which allows
echo cancellation.
After selecting, placing and wiring DSP 'Components', your 'System' will be compiled and sent to
the ECS via TCP/IP Ethernet port.
PRESET MANAGEMENT
The ECS includes two types of presets:
The Sub-Preset presets (Parameter -preset): They enable values of multiple parameters of the
same design, such as levels, gains, EQ, etc. to be restored either from the PC software, the remote
controllers or the control inputs.
The Master presets (Design preset): they enable completely different designs to be restored.
Application examples for this feature are hotel meeting rooms with removable walls.
These 'Master Presets' and 'Sub-Presets' residing in the ECS's memory which can be accessed in
many ways: PC, Logic inputs, Third party.
The limitation depends on memory usage. In Ateïs Studio, there is an indication of percentage
of used memory
SYSTEM CONTROL
Once a 'System' is stored into the ECSs memories, you can disconnect your PC and run it as a
standalone audio network. You can control all parameters like 'Channel Level', 'Master Volume' etc.
from assignable control sources or from front knob. There is a range of control devices built for the
system you can operate. The ECS integrates perfectly into third party control systems like: VITY, AMX,
Audace, Crestron, etc.
CONNECTION
Audio and control connections are made via Euro-block connectors on the rear panel of the
units.
COMPONENTS
Huge library with audio tools for all applications (routing, paging, signal processing, networking,
speaker managing, etc)
SYSTEM
• System design by drag & drop
• DSP design by drag & drop from component library
• Changeable appearance of the control elements
OFFLINE PROGRAMMING
Design and editing of 'DSP designs'