Artesyn PrAMC-7211 PNE3.0 Software Installation Guide (June 2014) - Manual (Page 47)

PrAMC-7211 Software Installation
PrAMC-7211-PNE3.0 Software Installation Guide (6806800L07B) 47
ACPI: IOAPIC (id[0x02] address[0xfec00000] gsi_base[0])
IOAPIC[0]: apic_id 2, version 0, address 0xfec00000, GSI 0-23
ACPI: INT_SRC_OVR (bus 0 bus_irq 0 global_irq 2 high edge)
ACPI: INT_SRC_OVR (bus 0 bus_irq 9 global_irq 9 high level)
Setting APIC routing to flat
Using ACPI (MADT) for SMP configuration information
SMP: Allowing 2 CPUs, 0 hotplug CPUs
Allocating PCI resources starting at 88000000 (gap: 80000000:60000000)
PERCPU: Allocating 26308 bytes of per cpu data
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 514093
Kernel command line: root=UUID=b1679603-05ff-481e-93e3-a2d68aa69072 ro
console=ttyS0,9600n8 crashkernel=128M@16M oops=panic panic=180
Initializing CPU#0
Preemptible RCU implementation.
PID hash table entries: 4096 (order: 12, 32768 bytes)
TSC: PIT calibration confirmed by PMTIMER.
TSC: using PIT calibration value
Detected 1500.097 MHz processor.
Console: colour dummy device 80x25
console [ttyS0] enabled
Dentry cache hash table entries: 262144 (order: 9, 2097152 bytes)
Inode-cache hash table entries: 131072 (order: 8, 1048576 bytes)
Checking aperture...
No AGP bridge found
Memory: 1922076k/2096192k available (3609k kernel code, 173248k reserved,
3602k data, 748k init)
Calibrating delay loop (skipped), value calculated using timer frequency..
3000.19 BogoMIPS (lpj=6000388)