Artesyn PrAMC-7211 PNE3.0 Software Installation Guide (June 2014) - Manual (Page 36)

PrAMC-7211 Software Installation
PrAMC-7211-PNE3.0 Software Installation Guide (6806800L07B) 36
2.3.3.1 Setting Up DHCP Configuration
Refer Setting Up DHCP Configuration on page 17 . In this procedure, replace filename
PrAMC721x-WR-3.0-BBS-RM01-1.0.2 /disk/pxelinux.0
with filename
PrAMC721x-WR-3.0-BBS-RM01-1.0.2 /usb/pxelinux.0
.
2.3.3.2 Changing BIOS Setting
Refer Changing BIOS Setting on page 19 .
2.3.3.3 Changing BIOS Setting Boot Option to USB Boot
Follow the steps mentioned below for changing the BIOS configuration to USB boot after
installation.
1. For changing boot configuration back to USB boot, in the BIOS Setup Utility screen, go to
the Boot tab and set the boot order as shown below: