Artesyn PrAMC-7211 PNE3.0 Software Installation Guide (June 2014) - Manual (Page 44)

PrAMC-7211 Software Installation
PrAMC-7211-PNE3.0 Software Installation Guide (6806800L07B) 44
[ Minimal BASH-like line editing is supported. For
the first word, TAB lists possible command
completions. Anywhere else TAB lists the possible
completions of a device/filename. ]
grub> root (hd0,0)
Filesystem type is ext2fs, partition type 0x83
grub> setup --stage2=/flash/boot/grub/stage2 (hd0)
Checking if "/boot/grub/stage1" exists... yes
Checking if "/boot/grub/stage2" exists... yes
Checking if "/boot/grub/e2fs_stage1_5" exists... yes
Running "embed /boot/grub/e2fs_stage1_5 (hd0)"... 17 sectors are
embedded.
succeeded
Running "install --stage2=/flash/boot/grub/stage2 /boot/grub/stage1 (hd0)
(hd0)1+17 p (hd0,0)/boot/grub/stage2 /boot/grub/menu.lst"... succeeded
Done.
System Going For Reboot ......
2.3.4 Software Booting Log
After Disk based/USB based installation procedure, the installed kernel boots up. The kernel log
is similar to as follows:
Linux version 2.6.27.39-pramc-7211-pne-3.0.2.1 ([email protected])
(gcc version 4.3.2 (Wind River Linux Sourcery G++ 4.3-237) ) #1 SMP PREEMPT
Wed Jun 30 11:16:02 IST 2010
Command line: root=UUID=b1679603-05ff-481e-93e3-a2d68aa69072 ro
console=ttyS0,9600n8 crashkernel=128M@16M oops=panic panic=180
KERNEL supported cpus: |