Artesyn PrAMC-7211 PNE3.0 Software Installation Guide (June 2014) - Manual (Page 16)

PrAMC-7211 Software Installation
PrAMC-7211-PNE3.0 Software Installation Guide (6806800L07B) 16
Example:
1. After untarring the contents of PrAMC721x-WR-3.0-BBS-RM01-1.0.2 , disk, usb, and
utils can be moved to any location which can be accessed by TFTP server.
The contents of PrAMC721x-WR-3.0-BBS-RM01-1.0.2 are moved to:
/tftpboot/blades/7211
/tftpboot/blades/7211/disk
/tftpboot/blades/7211/usb
/tftpboot/blades/7211/utils
/tftpboot/blades/7211/bsp
2. For disk based installation, modify the filename parameter in dhcpd.conf to
blades/7211/disk/pxelinux.0
As part of linuxrc, we assume that for disk installation the files that need to be picked will
be located in blades/7211/disk, that is, pxelinux.0 directory.
3. For usb based installation, modify the filename parameter in dhcpd.conf to
blades/7211/usb/pxelinux.0
2.3 Installation Procedure
This section describes the installation procedure for PrAMC- 7211 BBS software. The following
ways of installations are supported:
 Disk based
 USB based
2.3.1 Disk Based Installation
For installing the BBS software on PrAMC-7211 blade in 4440 chassis, perform the following:
1. Setup DHCP configuration, see Setting Up DHCP Configuration on page 17 .
2. Modify the contents of PrAMC721x-WR-3.0-BBS-RM01-
1.0.2/disk/pxelinux.cfg/default
file
From
TIMEOUT 50