Argox X Series - Manual (Page 77)

77
It’s strongly recommended to wear hand gloves during cleaning
progress.
Do not touch print head surface by bare hands or with any hard
equipment.
Water or spit should be kept away in case of corrosion on heating
elements.
Cleaning Direction
When cleaning the print head, always wipe in One-Way Direction -
from Left to Right only, or, from Right to Left only, to clean “Heating
Line” of print head gently without excessive stress.
Do not wipe back and forth, to avoid dust or dirt on cleaning cotton
would be attached onto print head again.
Special Caution:
Warranty of print heads will be void if print head serial number is
removed, altered, defected, or made illegible, under every
circumstance.
Cleaning the Roller
Using a cotton bud moistened with alcohol, clean the roll and
remove any attached glue.
Note: Clean the roller after it has been in contact with foreign
materials such as dust or adhesives.
Cleaning the Media Compartment
Clean the media compartment with a cotton bud that has been
moistened with a mild detergent. Every time a media roll is printed,
you should clean this compartment to reduce the incidence dust.