Analog Way PULSE2 (MIDRA) - Ref. PLS350 User Manual - Manual (Page 64)

64
8.3.1 Source Input selection
Same as Mixer mode
8.3.2 Input selection settings
Same as Mixer mode
8.3.3 Working with layers
Same as Mixer mode
Settings Layer A
Position YES
Size YES
Zoom YES
Transparency YES
Border YES
Opening effects YES
Closing effects YES
Smooth Move YES
The layers are used in the same way as the Mixer mode. A source has to be selected to activate the layers
settings. Each layer has its own settings, Layer A on Output #1 is not linked to Layer A on Output #2 in terms
of settings.
All layers settings are available in the Layer menu once the layer is selected.
NOTE: Take a look at the blinking of the Matrix mode button to always know on which output you are working
on.
8.3.4 Source Output selection
Same as Mixer mode.
NOTE: If you want to use HDCP content from your sources, be sure to plug HDCP compliant screens or
projectors. If it’s not the case, the output image could be disabled .
8.3.5 Output selection settings
To set up the outputs, go in the Output #1 or Output #2 menu and choose first the appropriate format/reso-
lution and then the adapted rate for your screens by using the knob button and the ENTER button.
Output# > Output Format > Output rate
You can also in the Output #2 menu, synchronise all the changes from the Output #1 to the Output #2 by
checking the case Synch w/Out 1. It allows you to set up both outputs at the same time.
Output #2 > Synch w/Out 1
Try to use the native resolution of your screens/projectors in order to obtain the best image quality.
NOTE: The output status can provide you all information about the output in real time. This feature is parti-
cularly needed when HDCP is used thanks to the HDCP status.
All changes have to be validated by pressing the Ok button in order to be saved
8.3.1 Source Input selection
8.3 Settings in native Matrix mode