AMETEK SGA Series - Manual (Page 96)

Index Sorensen SGA Series
Index 2 M550129-01 Rev AG
Ventilation, 2-2
M
Maintenance, 5-1
Cleaning/Inspection, 5-2
Fuses, 5-3
Preventive, 5-1
Maximum AC Current Ratings, 2-9
Model Number Decoding, 1-3
Mounting, 2-2
6U Rack Removal, 2-7
Rack Mounting, 2-3
O
Operation, 3-1
Constant-Current Mode, 3-12
Constant-Voltage Mode, 3-11
Front Panel, 3-10
Initial Setup, 3-10
Parallel, 3-29
Power-Up State, 3-10
Remote Current Programming, 3-18
Remote Output On/Off Control, 3-23
Remote Overvoltage Protection
Programming, 3-22
Remote OVP Reset, 3-22
Remote Sensing, 3-25
Remote Shutdown, 3-24
Remote Voltage Programming, 3-20
Series, 3-31
Outline Drawings, 2-15
Output Isolation
Negative Output Terminal, 1-6
Output Float Voltage, 1-6
Overvoltage Protection, 3-13
P
Parallel Operation, 3-29
Master/Slave Connections, 3-29
Physical Characteristics, 1-8
Polarized Output, 3-28
Protective Covers Assembly, 2-30, 4-8
R
Rack Mounting, 2-3
Rear Panel Drawings, 2-15
Remote Current Programming, 3-18
Resistance Control, 3-18
Voltage Source Control, 3-19
Remote Isolated Analog Interface Control,
3-14
Remote Output On/Off Control, 3-23
Contact Closure Control, 3-23
External Source Control, 3-23
Shutdown (S/D), 3-24
Remote Overvoltage Protection
Programming, 3-22
Remote Sensing, 1-5, 3-25
Error with Disconnected Sense, 3-25
Remote Shutdown, 3-24
Remote Voltage Programming, 3-20
Resistance Control, 3-20
Voltage Source Control, 3-21
Ripple/Noise, 1-7
S
Safety Disconnect Device, 2-8
Safety Ground Wire, 2-8
Series Operation, 3-31
Shaft Lock, 3-9
Specifications, 1-3
Electrical Characteristics, 1-3
Environmental Characteristics, 1-3
Output Isolation, 1-6
Parallel Operation, 1-6
Physical Characteristics, 1-8
Rated Current, 1-7
Rated Output Power, 1-4
Rated Voltage, 1-7
Remote Analog Interface, 1-5
Remote Sensing, 1-5
Ripple/Noise, 1-7
Series Operation, 1-6
W
Wire Selection, 2-11
Current Ratings, 2-11
Flexible Cable, 2-11
Voltage Drop, 2-14
Wire Size, 2-11