AMETEK SGA Series - Manual (Page 56)

Operation Sorensen SGA Series
3-6 M550129-01 Rev AG
Item Reference Functional Description
1 AC Input Connectors Connection for 3-phase AC.
2 AC Input Safety Ground
Connection for safety ground wire.
3 DC Output Bus Bars Positive (+) and negative ( –) outputs.
3a HV DC Output Studs
Positive (+) and negative ( –) outputs for 800V and
1000V models only.
4 PAR OUT
Parallel Out connector of master unit for configuring
parallel operation of units when connected to Parallel In
connector of slave unit; see Section 3.11.
5 PAR IN
Parallel In connector of slave unit for configuring parallel
operation of units when connected to Parallel Out
connector of master unit; see Section 3.11.
6 ANALOG CONTROL
Remote Analog Interface connector, J1, for
programming and monitoring signals of output, status
indication, and remote shutdown signals; see Table 3
–5
for individual pin descriptions.
7 SENSE Connector
Input connector, J3, for remote sensing of voltage at the
load to compensate for line drop in load cables; see
Section 3.9.
7a HV SENSE Connector
Input connector,J3, for remote sensing of voltage at the
load to compensate for line drop in load cables, 800V
and 1000V models only; see Section 3.9.
Refer to Figure 3-2, Figure 3-5, and Figure 3-8.
Table 3 –2. Rear Panel Connectors and Controls, Standard