AMETEK SGA Series - Manual (Page 95)

M550129-01 Rev AG Index 1
INDEX
A
AC Input Connector, 3U, 2-10
Screw Torque, 2-10
Agency Approvals, 1-3
Analog Control Connector (J1), 3-14
Designations and Functions, 3-17
Isolated Analog Voltage, 3-14
Return Connection, 3-14
C
Calibration and Verification
Remote Isolated Analog (Option), 4-5
Calibration and Verification, 4-1, 4-2
Constant-Current Mode, 4-3
Constant-Voltage Mode, 4-3
Resistive-Control Current Sources, 4-4
Calibration and Verification
Isolated Analog Constant-Current Mode,
4-5
Calibration and Verification
Isolated Analog Constant-Voltage Mode,
4-6
Constant-Current Mode, 3-12
Calibration and Verification, 4-3
Operation, 3-12
Constant-Voltage Mode, 3-11
Calibration and Verification, 4-3
Operation, 3-11
Contents of Shipment, 2-1
Controls and Indicators, 3-1
Analog Control (J1), 3-14
Front Panel ON/OFF Switch, 3-2
OVP Adjust Potentiometer, 3-2
OVP Set/Reset Button, 3-2
E
Electrical Characteristics, 1-3
Environmental Characteristics, 1-3
F
Flexible Cables, 2-11
Floating Negative Terminal, 2-8
Front Panel Drawing, 3-1
Fuses, 5-3
I
Initial Setup, 3-10
Input Overcurrent Protection, 2-8
Circuit Breaker/Fuse Rating, 2-8
Input/Output Connections, 2-8
Connectors, 2-9
Input Overcurrent Protection, 2-8
Input Terminal Connections, 2-10
Lugs, 2-10
Maximum AC Current Ratings, 2-9
Output Terminal Connections, 2-10
Safety Disconnect Device, 2-8
Safety Ground Wire, 2-8
Sense Connector Tools, 2-10
Inspection, 2-1
Installation Drawings, 2-15
L
Loads, 2-14
Inductive, 2-14
Stored-Energy, 2-14
Location, 2-2
Protected Environment, 2-2